- Carrier: 1- 100,000 hz carrier & frequency (4 million Hz carrier & frequency w electrodes)
- Frequency: Modulated 1-100,000Hz w all wave forms
(square, sine, etc.)
- Variable Intensity
- Power: 30 watts, conductive
- Noble Gas (argon,krypton,xenon,neon, NO helium)
- Addtl Hw: connects to BCX Ultra unit
click on image for detailed specs
We have already explained how the hand-held ray tubes transfer frequencies deep in to the body using both induction and conduction, higher voltage, and magnetic effect in the previous section. Since there is confusion and others misreporting about how the BCX Ultra delivers frequencies through the body, we decided to not only demonstrate this method in video but also how you can test it yourself. BCX Ultra Hand-held plasma Raytubes use Induction, Conduction and Radiation, however, the majority of the transfer occurs with Conduction. Here are some simple tests that you can do yourself.
A) First lay both hand-held plasma tubes beside each approximately 4" apart and notice the dim glow. The dim glow is due to little conduction via air. Next, hold both hand-held plasma tubes in each hand. Notice the glow gets much brighter. Why? Conduction is now occurring, completing the circuit through your body so that the full power of the tubes flow from one tube through the body to the other tube.
B) Second: When touching both tubes you will see the light gets brighter where you are touching the glass. The areas of the tube where you are touching that are brigher indicates where the current is transmitting out the tube and into your fingers. Note: Our stand alone plasma beam tubes do not show this because they use mostly radiation and induction method.
C) Third: Try this interesting experiment with a partner. Both of you stand side by side and with your outer hands holding one of the ray tubes. Have your inside hands drop down by your sides w palms facing down. Next, touch your wrists together (inside hands) and notice the increased flow of energy since now the circuit is complete. If you look closely while doing this you will see sparks of light. This test will give you a strong sensual sense of understanding the principles of the hand-held ray tubes operation.
You may ask how electricity goes through glass. Wikipedia. states. "The glass acts as a dielectric in a capacitor formed between the ionized gas and the hand." [1] Most of the power of the Hand-held Raytubes are emitted by Conduction, which is why they are held. Glass is an insulator, however with high frequencies, electricity passes right through it since it's dielectric characteristics change. It is an AC (alternating current) conductor and NOT a DC (direct current) conductor which as the previous stated tests prove it.
Ref: http://en.wikipedia.org/wiki/Plasma_globe
GLASS HAND-HELD RAY TUBES: Hold the glass part of the tubes in the hands, under the arms, or in direct contact with the skin on any area of the body. For more information click ' Accessories ' TAB above
GLASS HAND-HELD RAY TUBES and FOOT PLATES: Generally the glass tubes are used simultaneously with the footplates. This gives more frequency power into the body. Some people prefer to use the glass tubes alone.
The BCX Ultra uses both methods (induction & conduction) developed by Dr. Rife and his two business partners, John Crane and John Marsh.
The Induction method is the method where frequencies are delivered into the body using the "Induction" non-contact method via plasma ray beam tubes. Royal Rife developed this method which delivers a broad spectrum of energies. These energies range from visible light spectrum, conductive electron flow, electromagnetic fields, to electrostatic fields and more."Bioelectrical Impedance Analysis" tests show proof that the rife frequencies do penetrate the body.
Note: The BCX Ultra Hand-Held plasma Raytubes uses induction (like Rife's original equipment) & conduction. When a person holds both plasma ray tubes then the power increases dramatically due to the conduction that occurrs when both tubes are touching the body. This occurs because each hand-held Raytube are operating at a different polarity from each the other, creating an electrical attraction between them running from one tube to the other tube. This is an evolution of the Rife or Beam Tube that are incapable of this. check out the video demonstration
The Conduction method is the direct-contact method of delivering frequencies through the body using electrical (a positive and a negative polarity) via the metal electrodes which was used by John Crane and John Marsh. The 'Bioelectrical Impedance Analysis" tests also show frequencies delivered do pass through the skin and penetrate into the body. There drawback to using this method is the level of penetration which is overcome by using an RF radio carrier frequency. However if you use an RF radio carrier frequency the low audio frequencies will also penetrate the cells. For this reason the BCX Ultra has a carrier wave that can be set from 1hz to 4 Mhz (electrodes/BT-HFPCM2 beam tube) and up to 100,000 Hz for the hand-held plasma tubes.
Through the use of these two methods the BCX Ultra is able to output Dr.
Rife's RF frequencies. The BCX Ultra has a carrier
frequency so that the audio frequency can be piggyback
(carried) by the RF frequency (carrier) causing the
frequencies to penetrate into both the connective tissue
and the cells of the body. Both the RF carrier and audio
frequencies can run from 1hz to 4Mhz. There are
pre-stored programs already set to run as is or can be
modified. You can even store up to 250 custom programs.
The BCX Ultra gives you the ability to to do your own
research/testing. 'Scalar waves are emissions that are
not part of the electromagnetic (EM) spectrum. A few
innovative researchers have evidence that some plasma
devices emit scalar waves (as apparently did Royal
Rife's instrument)-and that these scalar waves help
regenerate the body as well as possibly devitalize
pathogens" Nenah Sylver PHD, The Rife Handbook (2011 Edition)
Misinformation on the BCX Ultra Hand Held Ray Tubes
There is some confusion out there about how the BCX Ultra carries frequencies through the body. BCX Ultra Hand-held Raytubes use Conduction, Induction, and Radiation, however, the main method is Conduction. Here are some simple tests that a lay person can observe and perform to prove that we do use the conduction method.
1. Lay both tubes next to each other about 4" apart and notice that the tubes glow dimly. They glow dimly because there is a little conduction through the air. Now, hold both tubes, one in each hand, and notice how bright they become. This is because you are now completing the circuit through your body allowing the full power of the ray tube circuit to flow through the tubes and then through you.
2. Touch the tubes and you will notice that the light gets brighter where you touch the glass. This indicates that current is exiting the tube and into your finger touching the tube. Note: Our stand alone beam tube units do not show much of this phenomenon because they are using mostly the induction and radiation methods.
3. This is a fun experiment. Especially, if your partner isn't aware of the result. Both you and your partner hold one of the ray tubes in your outside hand as you stand next to each other. With your inside hands let your hands droop down, palm facing down. Next, touch the top side of your wrists together and notice the pronounced shock you get as you complete the circuit. If you look closely while doing this you will see sparks. This test is only for those that need a very strong sensual persuasion to understand simple principles of ray tube operation.
Now, you are wondering how electricity goes through glass. Wikipedia. says this. "The glass acts as a dielectric in a capacitor formed between the ionized gas and the hand." [1] Most of energy of Raytubes is transmitted by Conduction, which is why you hold them. Yes, glass is an insulator, but at high frequencies, electricity passes through it because it's dielectric characteristics change. It is NOT a direct current (DC) conductor, but it IS an alternating current (AC) conductor as the simple tests above prove.
1. http://en.wikipedia.org/wiki/Plasma_globe
We have already explained how the hand-held ray tubes transfer frequencies deep in to the body using both induction and conduction, higher voltage, and magnetic effect in the previous section. Since there is confusion and others misreporting about how the BCX Ultra delivers frequencies through the body, we decided to not only demonstrate this method in video but also how you can test it yourself. BCX Ultra Hand-held plasma Raytubes use Induction, Conduction and Radiation, however, the majority of the transfer occurs with Conduction. Here are some simple tests that you can do yourself.
1. First: lay both hand-held plasma tubes beside each approximately 4" apart & notice the dim glow. The dim glow is due to little conduction via air. Next, hold both hand-held plasma tubes in each hand. Notice the glow gets much brighter. Why? Conduction is now occurring, completing the circuit through your body so that the full power of the tubes flow from one tube through the body to the other tube.
2. Second: When touching both tubes you will see the light gets brighter where you are touching the glass. The areas of the tube where you are touching that are brighter indicates where the current is transmitting out the tube and into your fingers. Note: Our stand alone plasma beam tubes do not show this because they use mostly radiation & induction method.
3. Third: Try this interesting experiment with a partner. Both of you stand side by side and with your outer hands holding one of the ray tubes. Have your inside hands drop down by your sides w palms facing down. Next, touch your wrists together (inside hands) and notice the increased flow of energy since now the circuit is complete. If you look closely while doing this you will see sparks of light. This test will give you a strong sensual sense of understanding the principles of the hand-held ray tubes operation.
You may ask how electricity goes through glass. Wikipedia. states. "The glass acts as a dielectric in a capacitor formed between the ionized gas and the hand." [1] Most of the power of the Hand-held Raytubes are emitted by Conduction, which is why they are held. Glass is an insulator, however with high frequencies, electricity passes right through it since it's dielectric characteristics change. It is an AC (alternating current) conductor & NOT a DC (direct current) conductor which as the previous stated tests prove it.
1. http://en.wikipedia.org/wiki/Plasma_globe
See demo video on how the POWER INCREASES when holding the
BCX Hand Held Ray Tubes (even > 30watts) click for more details
Read actual email submissions from other very satisfied customers.
Hand-held Ray Tubes Success"Since 1994 I have been using various designs of offset Square wave
Frequency generators. Purchased from other manufactures and made my own.
Utilizing frequencies with hand held Metal cylinders as the primary conducting source.
We were experiencing just ok results. Still was not satisfied... Research continued.
It was not until we embarked upon the Ray beam tube Plasma hand held wands, that we found outstanding results.
Very happy with the BCX and Ray tube technology. So far Ray beam tube technology is second to none.
Keeping us healthy and Happy.
Thanks again for your great customer service and continued support!"
Joe Bush Read Full Testimonial
"Just make sure you get the plasma hand held wands, because I found they increased the effectiveness of the machine a million times over. Without them the results were mediocre. With the plasma wands there hasn't any condition I couldn't cure or relieve. Now I never use the copper contact electrodes."
John White Read Full Testimonial
"TIPS - How to Buy a unit..."
Read Full Testimonial
"Testimonials .."
Read More Testimonials
